Announcement

Announcement Module
Collapse
No announcement yet.

Clutch Slave Cylinder Hydraulic Line Replacement?

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Clutch Slave Cylinder Hydraulic Line Replacement?

    I'm wondering how I can get ahold of a replacement clutch slave cylinder hydraulic line (that's all the shop manual says it is.) Is there a place online that's good for it, or is the dealer the best bet? I'm asking now because the parts department closes at 4pm here, so if I could order it online, that'd be sweet.

  • #2
    Check rockauto.com
    2011 Fusion SE V6 & 07 Honda Pilot EX-L
    98 3.0L SVT Sold 9-11-11
    99 3.0L SVT Silver Frost #1264 Sold 1-22-10
    95 SE MTX---Sold 9/14/07 sniff
    98 E1 SVT #4892 of 6535T-Red Sold 8-29-08

    Comment


    • #3
      This:


      http://www.contour.org/ceg-vb/showth...ht=clutch+line






      *CLICK HERE ---> 1995 SE 3L WITH MATCHING TRAILER <--- CLICK HERE*
      25 Contour / Mystiques and counting......
      I'M POWDER COATING AGAIN! PM ME FOR REQUESTS.

      Comment


      • #4
        That's the ticket!

        And thanks for the rockauto suggestion! Should be here soon.

        Comment


        • #5
          The shipping estimate lied and the part just came in today.

          I went outside to take the old one off, took the clip off, but it wouldn't budge. Its rusted or something onto the male end coming from the slave cylinder. I put a pair of vice grips on it, and romped on it, that didn't work either. I tried using a screwdriver to pry it off, broke the tip off of 3 of them by trying as such.

          Is there some kind of method to get this off? In the book it just says "remove retaining clip and pull out hydraulic line."

          Also, the one that's on the car now, the female piece that goes onto the slave cylinder line, its metal, the replacement one is plastic, I'm guessing that's just an improvement they made at some point over stock design.

          Comment


          • #6
            I had problems like that:

            Originally posted by blu_fuz View Post
            I got the damn thing out. Crazy! I think this was the most troublesum part on the entire build. Took the most time in the beginning, so I cut it and then another 3 hrs to finally get it apart....


            Originally posted by todras View Post
            Never seen anything like that at all. Never had an issue with that in the least.
            Originally posted by ctmystique View Post
            Glad you got it seperated. Those are some nasty pictures.
            Did you have to resort to heat?
            Originally posted by blu_fuz View Post
            Didn't go to heat for help. PB blasted it again 2 nights ago and let it sit. Hit it again with a wrench and it barely started to spin but not pull out. I used a flat head screwdriver and a hammer to pry it out from the hard line........
            *CLICK HERE ---> 1995 SE 3L WITH MATCHING TRAILER <--- CLICK HERE*
            25 Contour / Mystiques and counting......
            I'M POWDER COATING AGAIN! PM ME FOR REQUESTS.

            Comment

            Working...
            X