The shipping estimate lied and the part just came in today.
I went outside to take the old one off, took the clip off, but it wouldn't budge. Its rusted or something onto the male end coming from the slave cylinder. I put a pair of vice grips on it, and romped on it, that didn't work either. I tried using a screwdriver to pry it off, broke the tip off of 3 of them by trying as such.
Is there some kind of method to get this off? In the book it just says "remove retaining clip and pull out hydraulic line."
Also, the one that's on the car now, the female piece that goes onto the slave cylinder line, its metal, the replacement one is plastic, I'm guessing that's just an improvement they made at some point over stock design.