If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
P.S. Anyone want to show a picture of what the're talking about with the end links and such?
While the car is sitting on the ground, try to move that piece where the arrow is pointing from side to side. You cannot jack up one wheel either, its either both rear wheels in the air or on the ground.
bringing this thread back to life because it came up when i googled my problem.
got a rattle over any bump on pass/rear. replaced sway bar end links today cuz they looked shot and deff were and didnt fix it. pass side sway bar to frame mount is broke off on one side and half way torn on the other. i also have those bushings on the way. other side mount to frame looks ok. any suggestions on fixing that mount????? reinforced by welding? iv seen aftermarket U braces.
can anyone elaborate on the struts and strut mounts causing this annoying noise?