Originally posted by BURNTU2:
Originally posted by HoustonBullitt:
Also, how hard are these to install?



Not hard at all. I took my cluster out in 15 minutes. The hardest part might be slipping the gauges over the needles, if thats even possible. Hopefully we don't have to remove speedo and tach needles to do this.


When I did mine for my Zetec from procarparts.com, It was pretty easy. I just slid mine around the needle (very carefully) and the rest was cake..now I would assume it would be the same for these. The only prob I had was the first time I glued them on, I had a couple of small raised spots on the speedo guage and the needle kept sticking, took it back apart, re-glued, haven't had a prob since.

A Contour is not just a car, it's an experience 99 T-Red SE Zetec ATX Born April 16, 1999 98 E0 Silver Frost CSVT #3175/3565 Born August 21st, 1997 Stored at P.R.T. for the winter 67 Mustang 289 project car