Originally posted by CSVT#49:
I would wish this task apon no one...
removing the rear main wiring harness so I can rewire the damn thing because some stupid electrical engineer couldn't figure out he needed to have a different insulation on the cam and crank sensor wires.
.....wrong, Karl K (the electrical eng. who released the Contour wiring) did not make them, the issue was caused by the supplier AMERICAN Yazaki.....Building harnesses in a 'cleared new jungle' site in the far east, shipping them to Germany then on to USA tends to pick up a bit of
moisture!....'can you spell 'outsourcing!!!!!!
-'96 SE MTX 3L
-'98 SVT 1,173 of 6,535
-'05 Mazda 6s, loaded, g/f's ride
-Need a 96-00 manual on CD? PM or email me
| 
