95pgt-t
Hard-core CEG'er
hahahaha...yeah,i eventually did that:laugh:oh I see, your "optimization" was slapping a f@#!in 'stang TB on...you're a trickster...
-
Welcome to the Contour Enthusiasts Group, the best resource for the Ford Contour and Mercury Mystique.
You can register to join the community.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
optimized throttle body...kind of awesome
- Thread starter rollinstylee
- Start date
ff_drift_lol
New CEG'er
- Joined
- Aug 3, 2007
- Messages
- 28
The screws are peened at the end, they're not meant to be unscrewed so good luckDid you have any trouble removing the screws for the TPS and the butterfly plate? I couldn't get mine off with a crappy bench vice and a screwdriver without starting to strip them, so I gave up.
SVTJON87
Hard-core CEG'er
The screws are peened at the end, they're not meant to be unscrewed so good luck
you cut that part off before you take them out.:shrug: pretty easy if you make a clean cut.
rollinstylee
Hard-core CEG'er
you cut that part off before you take them out.:shrug: pretty easy if you make a clean cut.
I didn't even do that and I had no trouble unscrewing them with a cordless drill :shrug:
And no, I didn't damage the threads in the shaft by doing so. The new screws went in perfectly and securely.
Seriously, nothing about this is hard with common tools.
95pgt-t
Hard-core CEG'er
i've had to use one of those screw drivers that you hit w/a hammer and it turns to get the tps screws before...they can be pretty stubborn
99Mystique ATX
Hard-core CEG'er
i've had to use one of those screw drivers that you hit w/a hammer and it turns to get the tps screws before...they can be pretty stubborn
Or, you can grab the end very carefully with a pair of vice grips...
Leverage FTW!
BTW, you can get the screws out without cutting the backs off, I personally find it a lot easier to just cut the backs off and then they unscrew nicely with no risk of damaging the threads of the half-shaft...
95pgt-t
Hard-core CEG'er
think i'm going to go and experiment w/that extra svt tb i have now:laugh:Or, you can grab the end very carefully with a pair of vice grips...
Leverage FTW!
BTW, you can get the screws out without cutting the backs off, I personally find it a lot easier to just cut the backs off and then they unscrew nicely with no risk of damaging the threads of the half-shaft...
constrosity
CEG'er
- Joined
- Jul 3, 2007
- Messages
- 140
opt tb
opt tb
I opt my tb a while ago it really did make a difference! crazy what a little grinding and 2 countersunk screws can do.
opt tb
I opt my tb a while ago it really did make a difference! crazy what a little grinding and 2 countersunk screws can do.